Return to the Engine Rebuild Table of Contents.
Except for the tappets, all of the parts in this
picture are new. Because this is a new cam, the tappets had to be
reground. If the old cam is being reused and the tappets are still
useable make sure the tappets go back into their original positions
in the engine.
These are the ends of the camshaft. At left is the timing gear end
of the shaft.
The oil holes in the bearing journals should be
checked to be sure they are open.
The oil hole shown at left allows oil to flow between the camshaft
thrust plate and the face of the camshaft.
The hole shown at right allows oil to flow out the port to which the
cylinder head oil tube connects.
From left to right: the woodruff key that goes into the slot on the
camshaft, the timing gear spacer, the camshaft thrust plate.
The spacer washer should be about .006 inch thicker than the camshaft
thrust plate. On engines that have been rebuilt several times, the
camshaft thrust plate becomes worn. If the difference in the
thickness of the spacer and the plate is correct, but the end play of
the camshaft is too small, try placing the other surface of
the thrust plate against the camshaft.
This picture shows the valve spring, the valve, the "Roto-Cap" valve spring retainer
(bottom row, left) and the valve locks (bottom row, right).
When the valve spring is properly installed, the two coils that are closest together, toward the left in this picture, should be against the block.
The valve locks are tapered. The narrow end of the taper should be closest to the head of the valve. The Roto-Cap fits over the lock and holds the locks against the valve stem. The ridge in the locks engages in the grove in the end of the valve stem. The taper in the valve lock holds the Roto-Cap in place.
The Roto-Cap causes the exhaust valve to slowly rotate as the valve
opens and closes. This helps reduce carbon fouling of the exhaust
valve and its seat.
The valve tappets are installed, in the same holes from which they
were removed. Use lots of engine assembly lube on all surfaces that
contact another metal surface.
The main bearing dowels have not yet been installed.
This photo shows the camshaft in place.
Checking the end play of the camshaft. The thrust plate is bolted
into position, the spacer washer is placed on the camshaft, the
woodruff key is installed and the timing gear is placed on the
camshaft. The smooth surface of the spacer washer faces outward.
The side of the spacer that is shown in the picture faces the
cam.
The timing gear bolt is used to draw the timing gear into place.
Don't forget the washer on the bolt. Torque the bolt to 30 to 40
ft-lbs (40 to 54 N-m). The end play is .004 to .007 inch (.1 to
.18mm). I have been unable to think of an easy way to measure the
end play of the camshaft that does not involve the use of a dial
indicator.
The installation of the valve spring, keeper and locks.
The spring is being compressed so the valve locks can be
installed. Engine assembly lube is sticky enough to hold the valve
locks in place until the spring compressor can be released.
This is a wider view of the C-clamp valve spring compressor, which
will work with valve-in-block or with overhead valve springs, but the
cylinder head must be removed first. There are two other types that
will work with the cylinder head in place on the engine. One only works
on valve in block springs and the other only works on overhead valve
springs.
The exhaust valves are all installed. -- Eric Lawson (
elawson@inficad.com)
Continue to Page 4: The Crankshaft
Return to the Engine Rebuild Table of Contents.
CJ3B Home | Site Map | Updates | Search | Links | Bulletin Board